The below links contains a setup program for installing the MP6 software which is used to control the programmer, do like this:

From the start menu, press Settings --> Control panel --> add/remove software --> Install. Place the disc in the computers floppy drive and press next. And follow the instructions in the software.

Connect the programmer with the included 1.8m serial cable to a free comport on your computer. The Cable has an 9-pin d-sub connector, if there is only a 25-pin male connector on your computer you need an adapter. if you have an 25-pin female connector it can not be used since that is usually the connector for the printer (parallel port).

Connect the 9V battery or a 9V DC-adaptor, which gives regulated 9V DC output, at least 100mA, with minus in the center of the DC-plug.

This software below we have found to be fully compatible and suitable with our elvis product:

Latest Elvis software
Elvis Control Centre The title speaks for itself
Qload 0.1 loader program for programming external serial eeproms on already programmed cards.

Elvis Software
Mp6 Windows Software for the Elvis-Multiprogrammer
Mp7 Beta version Windows Software for the Elvis-Multiprogrammer
MPset 0.6 This Dos software is used to set your programmer into Phoenix or Smartmouse emulation mode
Dosprog 2.6 For programming smartcards based on the PIC16C84, PIC16F84 or PIC16F84A from microchip
EEprog 0.1 This Dos software is made for programming serial eeprom chips in the DIL-socket
Atmelprog 1.4 DOS-program for programming smartcards with Atmel chip
Siminfo 0.0 This software reads the phonebook from your GSM sim-card and displays it on the screen
CashCard 0.3 This software extracts the transaction data from a Cashcard
DTRlow 0.0 Used on Windows-ME to prevent the programmer from starting when starting Windows-ME